Howdy,
Starting with some of my specs:
Case - NZXT tempest 210
Mobo - Asrock z77 performance fatal1ty
CPU - intel core i5 3470
Graphics Card - GTX 650 ti
PSU - corsair cx600
RAM - Corsair Vengeance
So I just built this computer this morning and when I try starting it, it'll run just long enough for the fans to get spinning and for the Dr. Debug light to pop up and give me error code 55. Then it turns off and starts again, repeating this process until I turn off the power supply. Now error code 55 on Dr. Debug means "no memory installed". However I have two sticks of Corsair Vengeance installed.
It has never worked long enough to download any drivers and the monitor has never turned on. When I take out the RAM and start it without them it continues to run but gives me error code 53, which is "no usable memory detected". The monitor still won't wake up but the computer doesn't restart or anything. I have also tried a new stick of RAM and every possible combination of RAM to each of the four RAM slots.
I have also tried disconnecting the HDD, Graphics Card, and Disc Drive at the same time as I tested the RAM. The RAM was the only thing that made a difference. So that is my situation and any possible help would be great. Any additional information that may be needed I will post ASAP.
Thanks!
Starting with some of my specs:
Case - NZXT tempest 210
Mobo - Asrock z77 performance fatal1ty
CPU - intel core i5 3470
Graphics Card - GTX 650 ti
PSU - corsair cx600
RAM - Corsair Vengeance
So I just built this computer this morning and when I try starting it, it'll run just long enough for the fans to get spinning and for the Dr. Debug light to pop up and give me error code 55. Then it turns off and starts again, repeating this process until I turn off the power supply. Now error code 55 on Dr. Debug means "no memory installed". However I have two sticks of Corsair Vengeance installed.
It has never worked long enough to download any drivers and the monitor has never turned on. When I take out the RAM and start it without them it continues to run but gives me error code 53, which is "no usable memory detected". The monitor still won't wake up but the computer doesn't restart or anything. I have also tried a new stick of RAM and every possible combination of RAM to each of the four RAM slots.
I have also tried disconnecting the HDD, Graphics Card, and Disc Drive at the same time as I tested the RAM. The RAM was the only thing that made a difference. So that is my situation and any possible help would be great. Any additional information that may be needed I will post ASAP.
Thanks!